Pellet machine’s maintenance knowledge

Pellet machine is a kind of molding machine can make material into a specific shape. Pellet machie’s energy saving can be divided into two parts: one is the power part, the other is the heating part. Strip production line is not high cost, easy to operate, and easy to clean. Following methods can prolong the life of the machine.

1. Check the temperature rise of the motor and the oil tank, whether the local overheating of the bearing, the abnormal noise of the motor and gear, oil leakage, oil filter, the radial runout of the spline shaft and the contact gap with the screw end face.
2. The oil box should be clean and oil filter, replace the lubricating oil of this use after clarification, the above the oil clean again into the box to box clean once, and then released, and then into the new lubricating oil.
3. The new gear box operation "run in", should be replaced with new oil, every 4000 hours after the operation, the replacement of a new oil.
4. After the new gear box operation "run in", should be replaced with new oil, every 4000 hours after the operation, the replacement of a new oil.
5. Check the operation of the cooling water tank, vacuum pump, motor and so on. To observe whether there is a leak.
6. Cooling equipment and pipes should be clean, free of suspended impurities in industrial water. Water filters, water tanks to regularly check the cleaning, keep clean, replace the new water.
7. After using the machine, use the soft cotton cloth to wipe the equipment, in order to maintain a neat appearance; clean the dust in the dust box, to ensure good ventilation, so that the equipment to play the best drying effect.
8. Pay attention to check the wear and tear of easy wear parts, always pay attention to replace worn parts.