Our page uses cookies
We use cookies to personalize and enhance your browsing experience on our website. By clicking "Accept All", you agree to use cookies. You can read our Cookie Policy for more information.
LFM - Nuts Processing Solution Provider
86 19036958297
EN
Machine should be take care
Release Lime: 2017-01-06
Source: Longer - Nut Processing Solution Provider
With the development of technology, the development of economy, more and more users purchase Screw Press Machine, but there are a lot of customers due to not really grasp the correct use method of oil press machine, causing the due performance comes out without play, not only caused expelling out finished kernel quality is poor, and the production efficiency is very low, seriously affected its economic benefits and social benefits. Below I introduce some successful experience, for the benefit of oil press machine promotion.
1. Before use oil press machine, should first check the fastener is tightened, the rotating part is flexible, each bearing any grease, expelling unit are placed on smooth ground.
2. Before use oil press machine, should check the supply voltage switch must be in the off position.
3. After oil press machine starting motor, the rotor turning and equipment in the direction of. The first few minutes idling, observation has no abnormal noise, to confirm the normal operation, can feed production.
4. Oil press machine containing skin to accumulate, can adjust the air flow into the whirlwind, increase the suction air volume, in order to achieve the purpose of skin absorption.
5.Precision without being separated from the seed kernel contained in exceed the standard, should timely adjust the motor and a vibration sieve surface at an angle, improve the selection effect.
6. The production, people from the vibration of the motor at a distance, so as to avoid wounding.
7. Equipment should always clear the screen surface dirt and residual grain and sundries. In order to ensure the concentration effect of oil press machine must be covered when not in use, in a dry and Treasury, to avoid the sun and rain.
8. Every 50 hours of work should check the lubrication oil cup, gear box above shall not be short of oil, screw shaft adjusting screw bearing screw hole should be adjusted for each class in the grease is a dry grinding, is strictly prohibited.